+464 24 53 33 30
2200 products
Fast shipping
1 year warranty
Trygg e-handel

Installation of stuffs

 

 

Installation instructions 


 

Content

      1. Installation of auxiliary lights relay
      2. Installation of power resistors
      3. Installation of knightrider LED strip
      4. Installation of xenon conversion kit
      5. Installation of switchback bulbs
      6. Installation of Quick split connector for LED-strips
      7. Installation of soft-strips

 


 

 

How do I mount the auxiliary lights relay (SKU 3346005?

Back to top

DT-relä-installation

 


 

How do I use the power resistors?

Back to top

Our power resistors (1221, 1205, 2421, and 2405) are all connected in the same manner. Connect them parallell to the lamp with the quick-connectors that comes with the power resistors. 

Put a cable of the power resistor into the slot in the quick connector, put in the cable from the car in the other slot, and press together with pliers. Then you repeat the process with the grounded cable for the lamp. 

Regarding the 21W resistance, it's important to not place it on a heat-sensitive material since the resistors will get very warm. If there is no suitable material to mount it on, it can be mounted hanging in the air as long as no cables or other plastic comes into contact with it.

  Kopplingsschema för motståndQuick split connector

 


 

Installation instructions for Knight rider LED-strip

Back to top

The cables are connected accordingly. If you're unsure of how to do it, contact info@diodhuset.se or your local mechanic.Kablarna kopplas in enligt nedan.

Black cabel: Ground (-).
Red cabel: Non-fused power (5A)
Yellow cabel (if break signal is wanted): Connects to your brake-light's power-cable. Gives a strobing effect when you brake..
Green cabel (2 pcs, if turn signal is wanted): Connects to your turn signal's power. Gives a turn signal effect on half of the strip.

Remote controll:

A: Shifts between colours

B: Change flash pattern

C: Change speed of flash pattern

D: On/off

 


 

Mounting your xenon convertion kit (New, improved PDF-manual is available for download here!)

Back to top

 

 

Remove the dipped beam lamp and replace it with a xenon bulb. Important: DO NOT TOUCH THE GLASS! Xenonkonvertering
Drill 25 mm hole through the cover, so that the cables can connect to the lamp. Borra ett hål
Add the included cover and insert the cables. Xenonkonvertering
Mount the included ballast close to the lamp, and connect the cables to the lamp, and connect the original lamp-connection to the power-in of the ballast. Ballasten
 Re-mount the lamp. Gather up all cables. Make sure that no cables can be caught in movable parts and that no cables are shafing on sharp edges.  Montera strålkastare
Try your new xenon lamps out! Kontrollera!

 


 

Installation of switchback-bulb with one-connection socket BA15s, BAU15s, P27W (SKU 1214333, 1215333, 1225333)

Back to top

Installation instructions for switchback bulb Kopplingsschema för switchback-lampa

 

 


 

Installation directions for using the quick connector with LED-strips

Back to top

Installation of 420015

 


 

 Installation instructions for softstrips (SKU 42061440, 44061440)

Back to top

Installationsanvisning för soft-strip